Difference between revisions of "MC-Basic:axis.HOMEDISTANCE"
m (1 revision) |
|||
| (11 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Languages|MC-Basic:axis.HOMEDISTANCE}} | ||
{{MC-Basic | {{MC-Basic | ||
|SHORT FORM= | |SHORT FORM= | ||
| − | '' | + | <''axis''>.Hdis |
|SYNTAX= | |SYNTAX= | ||
| − | '' | + | <''axis''>.HomeDistance = <''value''> |
|AVAILABILITY= | |AVAILABILITY= | ||
| Line 28: | Line 29: | ||
|LIMITATIONS= | |LIMITATIONS= | ||
| − | The HOMERETURN property must be set in order to move to the HOMEDISTANCE location. Valid in communications phase 2 or higher | + | *The HOMERETURN property must be set in order to move to the HOMEDISTANCE location.Valid in communications phase 2 or higher |
| − | + | *To set the value within a task, the axis must be attached to that task (using the ATTACH command) | |
| − | To set the value within a task, the axis must be attached to that task (using the ATTACH command) | + | *Not supported in EtherCAT system |
|EXAMPLE= | |EXAMPLE= | ||
| Line 38: | Line 39: | ||
|SEE ALSO= | |SEE ALSO= | ||
| − | * [[ | + | * [[MC-Basic:ATTACH|ATTACH]] |
| − | * [[ | + | * [[MC-Basic:HOME|HOME]] |
| − | |||
| + | [[Category:Obsolete|axis.HomeDistance]] | ||
}} | }} | ||
Latest revision as of 07:41, 19 April 2017
| Language: | English • 中文（简体） |
|---|
This property specifies the distance between the home position and the position at the end of the homing procedure.
Short form
<axis>.Hdis
Syntax
<axis>.HomeDistance = <value>
Availability
All versions
Type
Double
Range
Limited by the drive.
Units
User position units.
Default
Dependent on the drive.
Scope
Task or Terminal
Limitations
- The HOMERETURN property must be set in order to move to the HOMEDISTANCE location.Valid in communications phase 2 or higher
- To set the value within a task, the axis must be attached to that task (using the ATTACH command)
- Not supported in EtherCAT system
Examples
a1.hdis = 0
?a1.hdis