Difference between revisions of "MC-Basic:axis.HOMETYPE"
| Line 43: | Line 43: | ||
|SEE ALSO= | |SEE ALSO= | ||
* [[MC-Basic:ATTACH|ATTACH]] | * [[MC-Basic:ATTACH|ATTACH]] | ||
| − | * [[ | + | * [[MC-Basic:HOME|HOME]] |
[[Category:Axystems:Obsolete|axis.HomeType ]] | [[Category:Axystems:Obsolete|axis.HomeType ]] | ||
}} | }} | ||
Revision as of 08:38, 22 May 2014
This property specifies the type of homing latch:
0 – Switch and marker
1 – Switch
2 – Marker
Short form
<axis>.HTyp
Syntax
<axis>.HomeType = <value>
Availability
All versions
Type
Long
Range
0 to 2
Default
Dependent on the drive
Scope
Task or Terminal
Limitations
- Drives without index signaling cannot use HomeType
- Valid in communications phase 2 or higher
- To set the value within a task, the axis must be attached to that task (using the ATTACH command)
- Not supported in EtherCAT system
Examples
?a1.Htyp
a1.htyp = 2