Difference between revisions of "MC-Basic:axis.HOMEDIRECTION"
(Created page with '{{MC-Basic |SHORT FORM= ''<axis>''.Hdir |SYNTAX= ''<axis>''.HomeDirection = ''<value>'' |AVAILABILITY= All versions |DESCRIPTION= This property specifies the direction of the …') |
|||
| (11 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Languages|MC-Basic:axis.HOMEDIRECTION}} | ||
{{MC-Basic | {{MC-Basic | ||
|SHORT FORM= | |SHORT FORM= | ||
| − | '' | + | <''axis''>.Hdir |
|SYNTAX= | |SYNTAX= | ||
| − | '' | + | <''axis''>.HomeDirection = <''value''> |
|AVAILABILITY= | |AVAILABILITY= | ||
| Line 11: | Line 12: | ||
|DESCRIPTION= | |DESCRIPTION= | ||
This property specifies the direction of the home search movement.<br> | This property specifies the direction of the home search movement.<br> | ||
| − | + | -1 – Moves axis in negative direction<br> | |
| − | + | 1 – Moves axis in positive direction | |
|TYPE= | |TYPE= | ||
| Line 30: | Line 31: | ||
|LIMITATIONS= | |LIMITATIONS= | ||
| − | Valid in communications phase 2 or higher | + | *Valid in communications phase 2 or higher |
| − | + | *To set the value within a task, the axis must be attached to that task (using the ATTACH command) | |
| − | To set the value within a task, the axis must be attached to that task (using the ATTACH command) | + | *Not supported in EtherCAT system |
|EXAMPLE= | |EXAMPLE= | ||
| Line 38: | Line 39: | ||
|SEE ALSO= | |SEE ALSO= | ||
| − | * [[ | + | * [[MC-Basic:ATTACH|ATTACH]] |
| − | * [[ | + | * [[MC-Basic:HOME|HOME]] |
| − | |||
| + | [[Category:Obsolete|axis.HomeDirection]] | ||
}} | }} | ||
Latest revision as of 07:32, 19 April 2017
| Language: | English • 中文（简体） |
|---|
This property specifies the direction of the home search movement.
-1 – Moves axis in negative direction
1 – Moves axis in positive direction
Short form
<axis>.Hdir
Syntax
<axis>.HomeDirection = <value>
Availability
All versions
Type
Long
Range
-1 or 1
Default
Dependent on the drive
Scope
Task or Terminal
Limitations
- Valid in communications phase 2 or higher
- To set the value within a task, the axis must be attached to that task (using the ATTACH command)
- Not supported in EtherCAT system
Examples
a1.hdir = 1