Difference between revisions of "MC-Basic:axis.HOMEVELOCITY"
(minor correction) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | {{Languages}} | + | {{Languages|MC-Basic:axis.HOMEVELOCITY}} |
{{MC-Basic | {{MC-Basic | ||
|SHORT FORM= | |SHORT FORM= | ||
| Line 11: | Line 11: | ||
|DESCRIPTION= | |DESCRIPTION= | ||
| + | {{Note|Not supported in EtherCAT and CANOpen systems. For information on homing, refer to | ||
| + | [[Program_Examples:Homing|Program Examples: Homing]]}} | ||
| + | |||
| + | |||
This property specifies the requested velocity to be used during the home procedure. | This property specifies the requested velocity to be used during the home procedure. | ||
Latest revision as of 16:39, 12 December 2017
| Language: | English • 中文（简体） |
|---|
 | NOTE |
| Not supported in EtherCAT and CANOpen systems. For information on homing, refer to Program Examples: Homing |
This property specifies the requested velocity to be used during the home procedure.
Short form
<axis>.Hvel
Syntax
<axis>.HomeVelocity = <value>
Availability
All versions
Type
Double
Range
Limited by the drive.
Units
User velocity units
Default
Dependent on the drive
Scope
Task or Terminal
Limitations
- Value must be less than VELOCITYMAXIMUM or VMAX is used
- Valid in communications phase 2 or higher
- To set the value within a task, the axis must be attached to that task (using the ATTACH command)
- Not supported in EtherCAT system
Examples
?a1.hvel
a1.hvel = 100