MC-Basic:HOME

From SoftMC-Wiki
Jump to: navigation, search
NOTE-Info.svgNOTE
The HOME command is not supported in EtherCAT and CANOpen systems. For information on homing, refer to Program Examples: Homing


This command starts the home procedure in the drive. It implicitly sets the axis into following mode and starts the homing move. HOMEVELOCITY and HOMEACCELERATION are the values used during the home move. The type of move is determined by the HOMETYPE property. The offset and distance are determined by HOMEOFFSET and HOMEDISTANCE. In simulation mode, issuing a homing procedure flags an error. During the homing procedure, the following flag is locked to the user. When the procedure is finished, the following mode can be changed.

Syntax

Home <axis>

Availability

  • All versions.

Scope

Task or Terminal

Limitations

  • Write only
  • Axis must be attached, enabled, not moving, and not a slave
  • Not supported in EtherCAT system

Examples

Home a1

See Also