MC-Basic:axis.HOMEPOLARITY

From SoftMC-Wiki
Revision as of 09:19, 22 May 2014 by Miborich (talk | contribs)
Jump to: navigation, search

This property specifies the homing switch edge.
1 – rising edge
2 – falling edge

Short form

<axis>.Hpol

Syntax

<axis>.HomePolarity = <value>

Availability

All versions

Type

Long

Range

1 or 2

Default

Dependent on the drive

Scope

Task or Terminal

Limitations

  • Valid in communications phase 2 or higher
  • To set the value within a task, the axis must be attached to that task (using the ATTACH command)
  • Not supported in EtherCAT system

Examples

a1.hpol = 1

See Also

Retrieved from "http://softmc.servotronix.com/index.php?title=MC-Basic:axis.HOMEPOLARITY&oldid=122813"