Difference between revisions of "MC-Basic:axis.CAPTUREINPUT"
m |
|||
| Line 42: | Line 42: | ||
* [[Axystems:MC-Basic:axis.RTCB1_MODE|axis.RTCB1_MODE]] | * [[Axystems:MC-Basic:axis.RTCB1_MODE|axis.RTCB1_MODE]] | ||
* [[Axystems:MC-Basic:axis.RTSB1_MODE|axis.RTSB1_MODE]] | * [[Axystems:MC-Basic:axis.RTSB1_MODE|axis.RTSB1_MODE]] | ||
| − | * [[ | + | * [[MC-Basic:IDNSTATE|IDNSTATE]] |
[[Category:Axystems:Obsolete|axis.CAPTUREINPUT]] | [[Category:Axystems:Obsolete|axis.CAPTUREINPUT]] | ||
}} | }} | ||
Revision as of 08:38, 22 May 2014
This property is used to set the digital input (on the drive) is used as the capture signal. This property takes the values 1, 2, or 3, indicating drive flex-input 1, 2, or 3. These values have keywords IN1, IN2, and IN3. The property sets the value 16 into the relevant IDN on the drive (IDN P123 for IN1; IDN P125 for IN2; IDN P127 for IN3). When the property is queried, the softMC checks the drive to see if the flex-input has been set for CAPTURE.</font>
 | NOTE |
| The property <axis>. CAPTUREINPUT is replaced in version 3.0 by the properties IN1MODE and IN1. |
Syntax
<axis>.CaptureInput = <input>
Availability
All versions
Type
Long
Range
1 to 3
Default
There is no default in the softMC. When the property is queried, the softMC gets the value from the drive.
Scope
Configuration, Task or Terminal
Limitations
- Not supported in EtherCAT system
Examples
a1.CaptureInput = IN2 'Use IN2 for capture