Difference between revisions of "MC-Basic:robot.ZMIN"
m (Text replace - "R/W" to "Read/Write") |
m (Text replace - "AllVersions" to "All versions") |
||
| Line 7: | Line 7: | ||
|AVAILABILITY= | |AVAILABILITY= | ||
| − | + | All versions | |
|DESCRIPTION= | |DESCRIPTION= | ||
Revision as of 14:52, 20 March 2014
This value is used in the pre-computation phase of the robot Cartesian movements (MOVES, CIRCLE). It is used to prevent robot collisions with its own body (base column).
Defines Z coordinate of the “lowest” robot position. No points below this plane are allowed.
 | IMPORTANT |
|
Always check the ZMIN value before configuring a new robot. The attached devices and parameters not taken into robot setup could significantly reduce the robots working area! |
Syntax
<ROBOT>.ZMin = <numeric expression>
Availability
All versions
Type
Double
Range
0.1-maxdouble
Units
Mm
Default
Depending on the robot parameter
Scope
Configuration, Task, Terminal
Limitations
Read/Write, Modal Only
Examples
Zmin = 60