Difference between revisions of "MC-Basic:robot.ZMIN"
m (note template) |
m (Text replace - "R/W" to "Read/Write") |
||
| Line 33: | Line 33: | ||
|LIMITATIONS= | |LIMITATIONS= | ||
| − | + | Read/Write, Modal Only | |
|EXAMPLE= | |EXAMPLE= | ||
Revision as of 09:16, 19 March 2014
This value is used in the pre-computation phase of the robot Cartesian movements (MOVES, CIRCLE). It is used to prevent robot collisions with its own body (base column).
Defines Z coordinate of the “lowest” robot position. No points below this plane are allowed.
 | IMPORTANT |
|
Always check the ZMIN value before configuring a new robot. The attached devices and parameters not taken into robot setup could significantly reduce the robots working area! |
Syntax
<ROBOT>.ZMin = <numeric expression>
Availability
AllVersions
Type
Double
Range
0.1-maxdouble
Units
Mm
Default
Depending on the robot parameter
Scope
Configuration, Task, Terminal
Limitations
Read/Write, Modal Only
Examples
Zmin = 60