Difference between revisions of "MC-Basic:axis.HOMETYPE"
m (1 revision) |
(Obsolete) |
||
| Line 14: | Line 14: | ||
1 – Switch<br> | 1 – Switch<br> | ||
2 – Marker | 2 – Marker | ||
| + | {{Note/Important| '''THIS PROPERTY IS OBSOLETE'''}} | ||
|TYPE= | |TYPE= | ||
| Line 42: | Line 43: | ||
* [[Axystems:MC-Basic:HOME|HOME]] | * [[Axystems:MC-Basic:HOME|HOME]] | ||
| − | + | [[Category:Axystems:Obsolete|axis.HomeType ]] | |
}} | }} | ||
Revision as of 08:48, 12 March 2014
This property specifies the homing latch Type
0 – Switch and marker
1 – Switch
2 – Marker
 | IMPORTANT |
| THIS PROPERTY IS OBSOLETE |
Short form
<axis>.HTyp
Syntax
<axis>.HomeType = <value>
Availability
All versions
Type
Long
Range
0 to 2
Default
Dependent on the drive
Scope
Task or Terminal
Limitations
Drives without index signaling cannot use HomeType. Valid in communications phase 2 or higher. To set the value within a task, the axis must be attached to that task (using the ATTACH command).
Examples
?a1.Htyp
a1.htyp = 2