Difference between revisions of "MC-Basic:axis.HOMEPOLARITY"
m (Miborich moved page Axystems:MC-Basic:axis.HOMEPOLARITY to MC-Basic:axis.HOMEPOLARITY: Global renaming of Axystems: namespace into (Main):) |
|||
Line 42: | Line 42: | ||
* [[MC-Basic:HOME|HOME]] | * [[MC-Basic:HOME|HOME]] | ||
− | [[Category | + | [[Category:Obsolete|axis.HomePolarity]] |
}} | }} |
Revision as of 09:19, 22 May 2014
This property specifies the homing switch edge.
1 – rising edge
2 – falling edge
Short form
<axis>.Hpol
Syntax
<axis>.HomePolarity = <value>
Availability
All versions
Type
Long
Range
1 or 2
Default
Dependent on the drive
Scope
Task or Terminal
Limitations
- Valid in communications phase 2 or higher
- To set the value within a task, the axis must be attached to that task (using the ATTACH command)
- Not supported in EtherCAT system
Examples
a1.hpol = 1