Difference between revisions of "MC-Basic:axis.HOMEACCELERATION"
m (Miborich moved page Axystems:MC-Basic:axis.HOMEACCELERATION to MC-Basic:axis.HOMEACCELERATION: Global renaming of Axystems: namespace into (Main):) |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Languages|MC-Basic:axis.HOMEACCELERATION}} | ||
{{MC-Basic | {{MC-Basic | ||
|SHORT FORM= | |SHORT FORM= | ||
| Line 45: | Line 46: | ||
* [[MC-Basic:HOME|HOME]] | * [[MC-Basic:HOME|HOME]] | ||
| − | [[Category | + | [[Category:Obsolete|Axis.HomeAcceleration ]] |
}} | }} | ||
Latest revision as of 07:26, 19 April 2017
| Language: | English • 中文（简体） |
|---|
This property specifies the requested acceleration or deceleration to be used during the HOME procedure.
Short form
<axis>.Hacc
Syntax
<axis>.HomeAcceleration = <value>
Availability
All versions
Type
Double
Range
Greater than 0 (limited by the drive)
Units
User acceleration units
Default
Dependent on the drive
Scope
Task or Terminal
Limitations
- Limited by the drive
- Valid in communications phase 2 or higher.
- To set the value within a task, the axis must be attached to that task (using the ATTACH command).
- Not supported in EtherCAT system
Examples
a1.hacc = 1000
If (a1.hacc<2000) Then
<code>
End If