Difference between revisions of "MC-Basic:axis.DRIVEOPMODE"
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Languages|MC-Basic:axis.DRIVEOPMODE}} | ||
{{MC-Basic | {{MC-Basic | ||
|SHORT FORM= | |SHORT FORM= | ||
| Line 6: | Line 7: | ||
<''axis''>.DriveOpMode<br> | <''axis''>.DriveOpMode<br> | ||
| − | ?'' <axis>''.DriveOpMode | + | ?'' <''axis''>''.DriveOpMode |
|AVAILABILITY= | |AVAILABILITY= | ||
| Line 46: | Line 47: | ||
Configuration, Task, Terminal | Configuration, Task, Terminal | ||
| − | Write Access Read/Write : | + | Write Access Read/Write : Read/Write in CP4 |
|LIMITATIONS= | |LIMITATIONS= | ||
Latest revision as of 01:58, 19 April 2017
| Language: | English • 中文（简体） |
|---|
This command allows you to change the operation mode of the controller. <axis>.DRIVEOPMODE may be changed from Primary Opmode to the Secondary Opmodes in CP4 when Primary Opmode ( IDN 32 ) and one or more Secondary Opmodes (IDN 33, IDN 34) are defined in CP 2 (Refer to the SERCOS IDN Reference Manual).
For example :
'sercos.phase=2
'primary OpMode definition as position opmode
wival drive=A1.dadd IDN=32 value=3
'secondary OpMode1 definition as torque opmode
wival drive=A1.dadd IDN=33 value=1
'secondary OpMode2 definition
wival drive=A1.dadd IDN=34 value=2
Syntax
<axis>.DriveOpMode
? <axis>.DriveOpMode
Type
Long
Range
0 to 2
0 = Opmode ,defined as Primary ( IDN 32 )
1 = Opmode ,defined as Secondary Opmode1 ( IDN 33 )
2 = Opmode ,defined as Secondary Opmode2 ( IDN 34 )
Default
0
Scope
Configuration, Task, Terminal
Write Access Read/Write : Read/Write in CP4
Limitations
Primary Opmode and Secondary Opmodes must be defined in CP2. Executed only in SERCOS communication phase 4.
Examples
?Axes1.DriveOpMode
Axes1.DriveOpMode=2