Difference between revisions of "MC-Basic:axis.POSITIONROLLOVERENABLE"
| Line 16: | Line 16: | ||
1 (ON) - Rollover is enabled | 1 (ON) - Rollover is enabled | ||
| − | {{Note| This property can indicates the nature of the axis also, it it is linear(0) or rotary(1). In some sens equivalent to [[MC-Basic | + | {{Note| This property can indicates the nature of the axis also, it it is linear(0) or rotary(1). In some sens equivalent to [[MC-Basic:axis.AXISTYPE|'''AXISTYPE''']]. It influences the dominant type of the group. }} |
|TYPE= | |TYPE= | ||
Revision as of 13:48, 4 August 2014
This property is used to enable or disable position rollover. When position rollover is enabled, the axis POSITIONROLLOVER property has relevance and the position command and feedback values are the modulus of the POSITIONROLLOVER property value.
0 (OFF) - Rollover is disabled
1 (ON) - Rollover is enabled
 | NOTE |
| This property can indicates the nature of the axis also, it it is linear(0) or rotary(1). In some sens equivalent to AXISTYPE. It influences the dominant type of the group. |
Short form
<axis>.Prolen
Syntax
<axis>.PositionRollOverEnable= <option>
?<axis>.PositionRollOverEnable
Availability
All versions
Type
Long
Range
0 (OFF)
1 (ON)
Default
0
Scope
Configuration, Task or Terminal
Limitations
- The position rollover setting may be changed only when the axis is disabled.
- To set the value within a task, the axis must be attached to that task (using the ATTACH command).
Examples
A1.PositionRollover = 1000 ‘Set rollover value
A1.PositionRollOverEnable = On ‘Enable position rollover