Point Redundancy
| Language: | English |
|---|
Point Redundancy is a flag that indicates the type of solution calculated by the Motion Controller to reach a specific point in space.
If a point was declared, for example; DIM SHARED PNT AS LOCATION OF XYZR, then the following sub-fields exists;
PNT.ARM, PNT.ELBOW, PNT.WRIST, PNT.TURN1, ..., PNT.TURN6
There are 3 ways to obtain Point Redundancy:
1. By using the property PNT.ARM (for SCARA only):
- 0 - Auto (closest solution), the default value
- 1 - Lefty (J2.PCMD < 0)
- 2 - Righty (J2.PCMD > 0)
2. Assighnments:
- PNT = Scara.HERE or PNT = Scara.SETPOINT
- In that case, flags are automatclly set during the assignment.
3. Constant Assignment:
- PNT = #{X,Y,Z,R;<'flag'>} by using the ";" separator between the location and the flag.
- Note: in the previous format, all flags were set to zero (for more information refer to 'SEE ALSO' section).
Syntax
Dim Shared PNT as Location Of XYZR
PNT = #{X,Y,Z,R;<'flag'>}
Availability
- FirmWare 0.4.20.1 and newer
Type
- long
Range
- 0-2
Default
- 0 - Auto flag
Scope
- Read/Write, Configuration, Task, Terminal
Limitations
1. There are no flags used when declaring location as a joint point (DIM SHARED JPNT AS JOINT OF XYZR).
2. Expressions are only allowed when all flags are equal or one of them is non-AUTO;
- for example, if A = #{X1,Y1,Z1;1} and B = #{X2,Y2,Z2;1}, the expression PNT = A+B is valid
Examples
move to a specific location with point redundancy flag = 1
move to the same location using point redundancy flag = 2
