Difference between revisions of "FAQ Motion Control"
(→on our test system, Jürgen get the exception 13134 when he tries to move a group in jog mode. Can you explain us this exception? Is this “just” a configuration problem?) |
|||
| Line 41: | Line 41: | ||
| − | It means the internal link length parameters and initial joint positions are such that a closed kinematics chain can not be closed (in case of MODEL 8 this is scissor kinematics) if you try to attach such a system the [[ | + | It means the internal link length parameters and initial joint positions are such that a closed kinematics chain can not be closed (in case of MODEL 8 this is scissor kinematics) if you try to attach such a system the [[Axystems:MC-Basic:robot.MODELENABLE|ModelEnable]] flag is set to zero. You need to bring the system to a meaningful position (or to change the links length) and the to se the modelenable flag again. |
[[Category:Axystems:Motion Control|FAQ]] | [[Category:Axystems:Motion Control|FAQ]] | ||
Revision as of 12:39, 6 June 2011
 | NOTE |
| If you miss any information concerning Motion Control in this wiki, please ask a question to the developer! |
Contents
- 1 I am changing my Vtran value but the velocity of my MOVE command is not influenced by it?
- 2 How the parameters: <mf>.VelocityMaxTrans <mf>.AccelerationMaxTrans, <mf>.JerkMaxTrans, <mf>.VelocityMaxRot, <mf>.AccelerationMaxRot, <mf>.JerkMaxRot affect linear and/or rotary conveyors?
- 3 Why am I getting >>Element entered into following mode<< notes?
- 4 on our test system, Jürgen get the exception 13134 when he tries to move a group in jog mode. Can you explain us this exception? Is this “just” a configuration problem?
I am changing my Vtran value but the velocity of my MOVE command is not influenced by it?
Vtran (translational - velocity) influences MOVES only. If you need to change velocity of the MOVE command you need to use vcruise.
- Velocity of MOVES (and CIRCLE for robots) is defined by Vtran and Vrot.
- velocity of MOVE is defined by vcruise.
How the parameters: <mf>.VelocityMaxTrans <mf>.AccelerationMaxTrans, <mf>.JerkMaxTrans, <mf>.VelocityMaxRot, <mf>.AccelerationMaxRot, <mf>.JerkMaxRot affect linear and/or rotary conveyors?
- In case of rotary conveyer these values are translated into angular values (i.e. divided by R n , n = 1,2,3)
- The xxxRot parameters are used only for moving frames that have orientation directly linked to the master axis.
Shortly, you can ignore xxxRot values
Why am I getting >>Element entered into following mode<< notes?
This note is printed when one of the following happens:
- axis entered following mode (either disabled or somebody explicitly commanded fmode=1/2)
- It is a single axis - means not a part of any attached group
- It is not moving (else it would be an error)
- It came unexpected - means the drive_control world is not the cause of disable (read: nobody gave "en=0")- might be somebody pressed an e-stop?
on our test system, Jürgen get the exception 13134 when he tries to move a group in jog mode. Can you explain us this exception? Is this “just” a configuration problem?
It means the internal link length parameters and initial joint positions are such that a closed kinematics chain can not be closed (in case of MODEL 8 this is scissor kinematics) if you try to attach such a system the ModelEnable flag is set to zero. You need to bring the system to a meaningful position (or to change the links length) and the to se the modelenable flag again.