Difference between revisions of "Program Examples:Camming by Virtual Master"
(→Creating Cam Table) |
(→Creating Cam Table) |
||
Line 53: | Line 53: | ||
Once the table is stored on the flash it can be re-loaded as: | Once the table is stored on the flash it can be re-loaded as: | ||
− | <pre | + | <pre> |
loadcamdata ct1.cam CamTable1 | loadcamdata ct1.cam CamTable1 | ||
</pre> | </pre> | ||
+ | |||
+ | |||
+ | == Crating master-slave relationship == |
Revision as of 11:03, 3 August 2014
Contents
Introduction
Slave axis is driven by a virtual(simulated) master axis
Setup
Both master and slave axes are set as in previous examples
Program example
Creating Cam Table
Declaring a cam-table type global variable:
common shared CamTable1 as cam
Creating an empty cam table:
- This table is not cyclic:
CamTable1.Cycle = 1
- Not linked to anything other cam-tabels:
CamTable1.Next = none CamTable1.Prev = none
- making it 10000 points
dim camsize as long = 10000 createcamdata camsize CamTable1
- Defining a 360 deg sine table:
for i = 1 to CamTable1.Size CamTable1.MasterData [i] = 360*(i-1)/CamTable1.Size ' Master in degrees CamTable1.SlaveData [i] = cam_amplitude *sin (CamTable1.MasterData [i] * pi/180) next
- Store the created file onto flash disk:
storecamdata ct1.cam CamTable1
Once the table is stored on the flash it can be re-loaded as:
loadcamdata ct1.cam CamTable1