Difference between revisions of "IP Address"
(→Connecting with motion controller) |
|||
| Line 32: | Line 32: | ||
On the Hypertherminal screen you should see the boot printouts. After mc booting is completed type: | On the Hypertherminal screen you should see the boot printouts. After mc booting is completed type: | ||
| + | |||
| + | '''/sbin/ifconfig''' | ||
| + | |||
[[Image:TANK-SETUP-SCR3.PNG]] | [[Image:TANK-SETUP-SCR3.PNG]] | ||
| + | |||
| + | |||
| + | You should get: | ||
| + | |||
| + | [[Image:TANK-SETUP-SCR4.PNG]] | ||
Revision as of 06:50, 23 June 2014
Contents
How to set default IP address
Wiring
Two connections are needed
Serial:
- Connect MC on COM1 via serial cable to your PC.
Ethernet
- Connect MC on Ethernet port 1 (LAN) via to the network where your PC is connected to (or directly with cross-cable to the PC)
Setting up serial communication
Open Windows- Hypertherminal (or similar) communication software and set the parameters:
This means:
- Baud rate 11520
- Data bits 8
- Parity: None
- Stop bits: 1
- Flow control: None
Connecting with motion controller
Once the communcation parameters are set and the serial cable is connected between MC and PC you should:
- turn on the MC
On the Hypertherminal screen you should see the boot printouts. After mc booting is completed type:
/sbin/ifconfig
You should get:
