Difference between revisions of "IP Address"
| Line 17: | Line 17: | ||
Open Windows- Hypertherminal (or similar) communication software and set the parameters: | Open Windows- Hypertherminal (or similar) communication software and set the parameters: | ||
| − | [[Image:TANK-SETUP-SCR0.PNG]] [[Image:TANK-SETUP-SCR1.PNG]] [[Image:TANK-SETUP-SCR2.PNG]] | + | [[Image:TANK-SETUP-SCR0.PNG]] [[Image:TANK-SETUP-SCR1.PNG]] [[Image:TANK-SETUP-SCR2.PNG]] |
| + | |||
| + | This means: | ||
| + | * Baud rate 11520 | ||
| + | * Data bits 8 | ||
| + | * Parity: None | ||
| + | * Stop bits: 1 | ||
| + | * Flow control: None | ||
Revision as of 06:46, 23 June 2014
How to set default IP address
Wiring
Two connections are needed
Serial:
- Connect MC on COM1 via serial cable to your PC.
Ethernet
- Connect MC on Ethernet port 1 (LAN) via to the network where your PC is connected to (or directly with cross-cable to the PC)
Setting up serial communication
Open Windows- Hypertherminal (or similar) communication software and set the parameters:
This means:
- Baud rate 11520
- Data bits 8
- Parity: None
- Stop bits: 1
- Flow control: None