Difference between revisions of "MC-Basic:HOLD"
| Line 23: | Line 23: | ||
* ''[[AXY:Operational_Modes | Operational Modes]]'' | * ''[[AXY:Operational_Modes | Operational Modes]]'' | ||
}} | }} | ||
| − | [[Category | + | [[Category:OperationalModes]] |
Revision as of 09:20, 22 May 2014
Stopping the axis tcmd interpolation immediately.
 | IMPORTANT |
| It does not necessarily stop the axis physical motion! |
 | NOTE |
| In case wrongly issued in a OPMODE different from TORQUEMODE the regular STOP command will be issued instead! |
Depending on the value of axis.HOLDTYPE actual tcmd could be reduced to zero.
Syntax
HOLD <axis> {HoldType = <value>}
Availability
from 4.9.0
Examples
Hold Ax1
See Also