Difference between revisions of "MC-Basic:STEPIN"
| Line 38: | Line 38: | ||
* [[MC-Basic:ADDBREAKPOINT|ADDBREAKPOINT]] | * [[MC-Basic:ADDBREAKPOINT|ADDBREAKPOINT]] | ||
* [[MC-Basic:BREAKPOINTLIST|BREAKPOINTLIST]] | * [[MC-Basic:BREAKPOINTLIST|BREAKPOINTLIST]] | ||
| − | * [[ | + | * [[MC-Basic:CLEARBREAKPOINT|CLEARBREAKPOINT]] |
* [[Axystems:MC-Basic:CONTINUETASK|CONTINUETASK]] | * [[Axystems:MC-Basic:CONTINUETASK|CONTINUETASK]] | ||
* [[Axystems:MC-Basic:IDLETASK|IDLETASK]] | * [[Axystems:MC-Basic:IDLETASK|IDLETASK]] | ||
Revision as of 08:36, 22 May 2014
This command executes the program step by step. If a CALL instruction is encountered, single stepping continues within the subprogram. If a parent task is in step mode, all events are also in step mode, which means that all events associated with the task are not running, but event scanning continues to run.
If an error occurs while single stepping, the STEPIN (STEPOUT, STEPOVER) commands retry the line which caused the error. The error must be corrected before the task continues.
Syntax
StepIn <task>
Availability
All versions
Scope
Terminal
Limitations
Task must be in one of the following states ready (7), stopped (2), error (4), killed (10)
Examples
StepIn MAKECUT.prg