Difference between revisions of "AXY:MC-Basic:axis.DECELERATION"
m (1 revision) |
m |
||
| Line 1: | Line 1: | ||
{{MC-Basic | {{MC-Basic | ||
|SHORT FORM= | |SHORT FORM= | ||
| − | '' | + | <''axis''>.Dec |
|SYNTAX= | |SYNTAX= | ||
| − | '' | + | <''axis''>.Deceleration = <''expression''><br> |
| − | ?'' | + | ?<''axis''>.Deceleration |
|AVAILABILITY= | |AVAILABILITY= | ||
| Line 33: | Line 33: | ||
|LIMITATIONS= | |LIMITATIONS= | ||
The ratio between Jerk and Deceleration is limited by the following relation:<br> | The ratio between Jerk and Deceleration is limited by the following relation:<br> | ||
| − | Jerk/Dec < 0.9 | + | Jerk/Dec < 0.9 × π/5T |
where T is the sample time in seconds. | where T is the sample time in seconds. | ||
| − | For a cycle time of 2 | + | For a cycle time of 2 ms, this value is 282.74. Use SMOOTHFACTOR to have jerk calculated automatically. |
To set the value within a task, the axis must be attached to that task (using the ATTACH command). | To set the value within a task, the axis must be attached to that task (using the ATTACH command). | ||
Revision as of 15:13, 16 March 2014
This property sets the deceleration rate of the motion profile. When executing a motion command, deceleration should be less than or equal to DECELERATIONMAX. If it is greater, the motion is executed at the DECELERATIONMAX value.
This property can be used inside a motion command to override the permanent value.
Short form
<axis>.Dec
Syntax
<axis>.Deceleration = <expression>
?<axis>.Deceleration
Availability
All versions
Type
Double
Range
Greater than 0
Units
User axis acceleration units, as given by <axis>.AccelerationFactor
Default
1000
Scope
Configuration, Task or Terminal
Limitations
The ratio between Jerk and Deceleration is limited by the following relation:
Jerk/Dec < 0.9 × π/5T
where T is the sample time in seconds.
For a cycle time of 2 ms, this value is 282.74. Use SMOOTHFACTOR to have jerk calculated automatically.
To set the value within a task, the axis must be attached to that task (using the ATTACH command).
Examples
Xaxis.deceleration = 1e10
Move Xaxis 100 dec = 2e10