Difference between revisions of "MC-Basic:axis.HOMEPOLARITY"
m (1 revision) |
(Obsolete) |
||
| Line 14: | Line 14: | ||
2 – falling edge | 2 – falling edge | ||
| + | {{Note/Important| '''THIS PROPERTY IS OBSOLETE'''}} | ||
|TYPE= | |TYPE= | ||
Long | Long | ||
| Line 41: | Line 42: | ||
* [[Axystems:MC-Basic:HOME|HOME]] | * [[Axystems:MC-Basic:HOME|HOME]] | ||
| − | + | [[Category:Axystems:Obsolete|axis.HomePolarity]] | |
}} | }} | ||
Revision as of 08:40, 12 March 2014
This property specifies the homing switch edge.
1 – rising edge
2 – falling edge
 | IMPORTANT |
| THIS PROPERTY IS OBSOLETE |
Short form
<axis>.Hpol
Syntax
<axis>.HomePolarity = <value>
Availability
All versions
Type
Long
Range
1 or 2
Default
Dependent on the drive
Scope
Task or Terminal
Limitations
Valid in communications phase 2 or higher.
To set the value within a task, the axis must be attached to that task (using the ATTACH command).
Examples
a1.hpol = 1