Difference between revisions of "MC-Basic:axis.HOMEDIRECTION"
m (1 revision) |
(Obsolete) |
||
| Line 13: | Line 13: | ||
-1 – Move axis in negative direction<br> | -1 – Move axis in negative direction<br> | ||
1 – Move axis in positive direction | 1 – Move axis in positive direction | ||
| + | |||
| + | {{Note/Important| '''THIS PROPERTY IS OBSOLETE'''}} | ||
|TYPE= | |TYPE= | ||
| Line 41: | Line 43: | ||
* [[Axystems:MC-Basic:HOME|HOME]] | * [[Axystems:MC-Basic:HOME|HOME]] | ||
| − | + | [[Category:Axystems:Obsolete|axis.HomeDirection]] | |
}} | }} | ||
Revision as of 13:57, 11 March 2014
This property specifies the direction of the home search movement.
-1 – Move axis in negative direction
1 – Move axis in positive direction
 | IMPORTANT |
| THIS PROPERTY IS OBSOLETE |
Short form
<axis>.Hdir
Syntax
<axis>.HomeDirection = <value>
Availability
All versions
Type
Long
Range
-1 or 1
Default
Dependent on the drive
Scope
Task or Terminal
Limitations
Valid in communications phase 2 or higher.
To set the value within a task, the axis must be attached to that task (using the ATTACH command).
Examples
a1.hdir = 1