Difference between revisions of "MC-Basic:axis.HOMEOFFSET"
m (1 revision) |
(Obsolete) |
||
| Line 12: | Line 12: | ||
This property determines the motor position feedback relative to the machine's zero point. | This property determines the motor position feedback relative to the machine's zero point. | ||
| + | {{Note/Important| '''THIS PROPERTY IS OBSOLETE'''}} | ||
|TYPE= | |TYPE= | ||
Double | Double | ||
| Line 41: | Line 42: | ||
* [[Axystems:MC-Basic:HOME|HOME]] | * [[Axystems:MC-Basic:HOME|HOME]] | ||
| − | + | [[Category:Axystems:Obsolete|axis.HomeAcceleration]] | |
}} | }} | ||
Revision as of 08:37, 12 March 2014
This property determines the motor position feedback relative to the machine's zero point.
 | IMPORTANT |
| THIS PROPERTY IS OBSOLETE |
Short form
<axis>.Hoff
Syntax
<axis>.HomeOffset = <value>
Availability
All versions
Type
Double
Range
Limited by the drive.
Units
User position units
Default
Dependent on the drive
Scope
Terminal and Task
Limitations
Valid in communications phase 2 or higher.
To set the value within a task, the axis must be attached to that task (using the ATTACH command).
Examples
?a1.hoff
a1.hoff = -50