IP Address

Cable Connections

Two connections are needed:

Serial:

• Connect MC on COM1 via serial cable to your PC.

Ethernet

• Connect MC on Ethernet port 1 (LAN) via to the network where your PC is connected to (or directly with cross-cable to the PC)

Serial Communication Parameters

Open Windows HyperTerminal (or similar) communication software and set the parameters:

Connecting to Motion Controller

Once the communication parameters are set and the serial cable is connected between MC and PC, turn on the MC.

On the HyperTerminal screen you will see the boot printouts. After MC boot is complete, type:

/sbin/ifconfig'''

You will see:

Instead of 10.4.20.171 as shown above, the current IP address of your MC will be displayed.

Setting Temporary IP Address

Simply type

sudo /sbin/ifconfig eth0 90.0.0.51

Your MC will get the new IP address.

	NOTE
	The above example sets the permanent IP address only, this address will vanish immediately after

Setting Permanent Default IP Address

Once the temporary IP address has been set, you can connect to the MC with ControlStudio:

	NOTE
	Your PC must have Ethernet port configured in the same address space e.g. 90.0.0.1

Creating FWCONFIG File

Create text file FWCONFIG (no extension) with the following content:

ipaddressmask 90.0.0.51:255.0.0.0
sleep 20
ramdisksize=64 mByte
StringPreload=300000

On more details how to set-up the FWCONFIG file take a look at: FWCONFIG syntax

Setting the IP Address of the Motion Controller

Save the file in the current directory of the ControlStudio and send it to MC using:

-->privilegelevel=1
-->send FWCONFIG

typed from the terminal windows of ControlStudio.

Now you can reset the MC and it will boot up with the 90.0.0.51 address. This is how the default IP address is set, the non-default address cab be set using SYS.IPADDRESSMASK command

Getting the IP Address from DHCP Server

Once the temporary IP address has been set, you can connect to the MC with ControlStudio:

	NOTE
	Your PC must have Ethernet port configured in the same address space e.g. 90.0.0.1

Creating FWCONFIG File

Create text file FWCONFIG (no extension) with the following content:

ipaddressmask dhcp
sleep 20
ramdisksize=64 mByte
StringPreload=300000

For more information on setting up the FWCONFIG file, refer to: FWCONFIG syntax

Setting the IP Address of the Motion Controller

Save the file in the current directory and send it to MC using:

-->privilegelevel=1
-->send FWCONFIG

typed from the terminal windows of ControlStudio.

Now you can reset the MC and it will boot up with the IP address from DHCP pool. This is how the default IP address is set, the non-default address can be set using SYS.IPADDRESSMASK command.