Difference between revisions of "IP Address"
| Line 25: | Line 25: | ||
* Stop bits: 1 | * Stop bits: 1 | ||
* Flow control: None | * Flow control: None | ||
| + | == Connecting with motion controller == | ||
| + | |||
| + | Once the communcation parameters are set and the serial cable is connected between MC and PC you should: | ||
| + | |||
| + | * turn on the MC | ||
| + | |||
| + | On the Hypertherminal screen you should see the boot printouts. After mc booting is completed type: | ||
| + | |||
| + | [[Image:TANK-SETUP-SCR3.PNG]] | ||
Revision as of 06:49, 23 June 2014
Contents
How to set default IP address
Wiring
Two connections are needed
Serial:
- Connect MC on COM1 via serial cable to your PC.
Ethernet
- Connect MC on Ethernet port 1 (LAN) via to the network where your PC is connected to (or directly with cross-cable to the PC)
Setting up serial communication
Open Windows- Hypertherminal (or similar) communication software and set the parameters:
This means:
- Baud rate 11520
- Data bits 8
- Parity: None
- Stop bits: 1
- Flow control: None
Connecting with motion controller
Once the communcation parameters are set and the serial cable is connected between MC and PC you should:
- turn on the MC
On the Hypertherminal screen you should see the boot printouts. After mc booting is completed type:
