Difference between revisions of "MC-Basic:STEPOVER"
| Line 35: | Line 35: | ||
|SEE ALSO= | |SEE ALSO= | ||
* [[MC-Basic:ADDBREAKPOINT|ADDBREAKPOINT]] | * [[MC-Basic:ADDBREAKPOINT|ADDBREAKPOINT]] | ||
| − | * [[ | + | * [[MC-Basic:BREAKPOINTLIST|BREAKPOINTLIST]] |
* [[Axystems:MC-Basic:CLEARBREAKPOINT|CLEARBREAKPOINT]] | * [[Axystems:MC-Basic:CLEARBREAKPOINT|CLEARBREAKPOINT]] | ||
* [[Axystems:MC-Basic:CONTINUETASK|CONTINUETASK]] | * [[Axystems:MC-Basic:CONTINUETASK|CONTINUETASK]] | ||
Revision as of 08:35, 22 May 2014
This command executes the program step by step without entering subprograms. The subprogram is executed, but the individual steps are not seen.
Syntax
StepOver <task>
Availability
All versions
Scope
Terminal
Limitations
Task must be in one of the following states ready (7), stopped (2), error (4), killed (10)
Examples
StepOver MAKECUT.prg