Difference between revisions of "MC-Basic:STOPPHASE"
m (1 revision) |
|||
| (2 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Languages|MC-Basic:STOPPHASE}} | ||
{{MC-Basic | {{MC-Basic | ||
|SHORT FORM= | |SHORT FORM= | ||
| Line 46: | Line 47: | ||
|SEE ALSO= | |SEE ALSO= | ||
| − | * [[ | + | * [[MC-Basic:GEARING & CAMMING|GEARING & CAMMING]] |
}} | }} | ||
Latest revision as of 07:45, 28 April 2017
| Language: | English • 中文（简体） |
|---|
Stop the Phaser command . It stops the convergence stage of the Phaser command. Ratio is used to correlate between master and slave unit and to control the stop rate.
Syntax
StopPhase <slave axis> ratio = <ratio factor>
Availability
Versions 4.0.x and higher
Range
<offset> : mindouble to maxdouble
<ratio factor> : above then zero
Units
<offset> : master position units
<ratio factor> : [master position unites / slave position units]
Default
<ratio factor> : 1
Scope
Task, terminal
Limitations
Axis must be slaved, command can’t be executed without offset value. Valid for axis only.
Examples
A1.mastersource = a2.pcmd
A1.slave = CAM
Phase a1 10 ratio = 1
StopPhase A1 ratio =10