Difference between revisions of "Program Examples:Cyclic recording of one Axis"
(→Program) |
m (→Introduction) |
||
| (5 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
= Introduction = | = Introduction = | ||
| − | + | The following example demonstrate how to record an external interference in single axis. <br> | |
| + | the example was written for a motor without load, in lab conditions. Spinning the motor in low velocity and after couple of seconds hold the motor by using external device to stop it. | ||
= Program flow = | = Program flow = | ||
| − | |||
| − | + | The program refer to axis that fail during motion. <br> | |
| − | + | The program set motion conditions for an axis and start recording motion data. <br> | |
| − | + | Under the conditions the user set, the program stop recording and stop axis motion. | |
| − | The | ||
| − | |||
| − | |||
| − | |||
| − | The program | ||
| − | |||
= Program = | = Program = | ||
| Line 85: | Line 79: | ||
[[Image:GearMotor.png|GearMotor.png|250px]] | [[Image:GearMotor.png|GearMotor.png|250px]] | ||
--> | --> | ||
| − | |||
| − | |||
| − | |||
Latest revision as of 12:45, 19 June 2017
Introduction
The following example demonstrate how to record an external interference in single axis.
the example was written for a motor without load, in lab conditions. Spinning the motor in low velocity and after couple of seconds hold the motor by using external device to stop it.
Program flow
The program refer to axis that fail during motion.
The program set motion conditions for an axis and start recording motion data.
Under the conditions the user set, the program stop recording and stop axis motion.
Program
'------------------------------------------------------------------------------
' File: <Cyclic_rec>.prg
' Purpose: To record an external interference to axis
' Version: 1.00
' Author: <Inon Shoshani>
' Description: External interference recording - look for the Introduction
' History: 2017-06-12 V1.00
' Created
'------------------------------------------------------------------------------
common shared ii as long = 1 '' define a var as a flag
program
attach a1
Record CycRec.rec 500 Gap = 4 RingBuffer=On RecData = a1.VFb ,a1.VCmd
RecordOn
a1.En= 1
jog a1 360 ''set motion command 360 degree per second.
sleep 1000 '' wait the velocity to become constant
while (ii=1) ''run while the falg is up
sleep 10 ''10 millisecond for the proccesor
if a1.VFb <50 then ''if the motion fail
RecordClose '''stop the recording
sleep 10
print "---------" '' monitoring the fault
print "fail time:", sys.Time '' monitoring the fault
print "a1.VFb = " , a1.VFb '' monitoring the fault
ii=0 ''flag down
a1.En =0
detach a1
end if
end while
end program ' <Cyclic_rec>.prg