Difference between revisions of "MC-Basic:HOLD"
m |
|||
| (3 intermediate revisions by one other user not shown) | |||
| Line 17: | Line 17: | ||
* [[MC-Basic:axis.OPMODE|OPMODE]] | * [[MC-Basic:axis.OPMODE|OPMODE]] | ||
* [[MC-Basic:axis.HOLDTYPE|HOLDTYPE ]] | * [[MC-Basic:axis.HOLDTYPE|HOLDTYPE ]] | ||
| − | * [[ | + | * [[MC-Basic:axis.TORQUECHANGERATIO|TIMETOTORQUE ]] |
| − | * [[ | + | * [[OperationalModes| Operational Modes]] |
<br><br> | <br><br> | ||
| − | * ''[[AXY:MC_Operational_Modes | MC Operational Modes]]'' | + | <!-- * ''[[AXY:MC_Operational_Modes | MC Operational Modes]]'' |
| − | * ''[[AXY:Operational_Modes | Operational Modes]]'' | + | * ''[[AXY:Operational_Modes | Operational Modes]]'' --> |
}} | }} | ||
| − | [[Category | + | [[Category:OperationalModes]] |
Latest revision as of 09:03, 21 August 2014
Stopping the axis tcmd interpolation immediately.
 | IMPORTANT |
| It does not necessarily stop the axis physical motion! |
 | NOTE |
| In case wrongly issued in a OPMODE different from TORQUEMODE the regular STOP command will be issued instead! |
Depending on the value of axis.HOLDTYPE actual tcmd could be reduced to zero.
Syntax
HOLD <axis> {HoldType = <value>}
Availability
from 4.9.0
Examples
Hold Ax1
See Also