MC-Basic:axis.CAPTUREINPUT

From SoftMC-Wiki
Jump to: navigation, search
Language: English  • 中文(简体)‎

This property is used to set the digital input (on the drive) is used as the capture signal. This property takes the values 1, 2, or 3, indicating drive flex-input 1, 2, or 3. These values have keywords IN1, IN2, and IN3. The property sets the value 16 into the relevant IDN on the drive (IDN P123 for IN1; IDN P125 for IN2; IDN P127 for IN3). When the property is queried, the softMC checks the drive to see if the flex-input has been set for CAPTURE.</font>


NOTE-Info.svgNOTE
The property <axis>. CAPTUREINPUT is replaced in version 3.0 by the properties IN1MODE and IN1.

Syntax

<axis>.CaptureInput = <input>

Availability

All versions

Type

Long

Range

1 to 3

Default

There is no default in the softMC. When the property is queried, the softMC gets the value from the drive.

Scope

Configuration, Task or Terminal

Limitations

  • Not supported in EtherCAT system

Examples

a1.CaptureInput = IN2  'Use IN2 for capture

See Also